What the Media Does
The wheel media stores and releases both heat and moisture. Its coating decides how much water vapour transfers and how the wheel ages.
Media Types
- Aluminium (sensible) - no moisture transfer, lowest cost
- Molecular-sieve coating - strong latent transfer, durable
- Desiccant paper - high moisture uptake, needs careful humidity control
- Polymer / hybrid - corrosion-resistant, good for harsh air
Selection Criteria
- Required latent effectiveness at your humidity ratio
- Air cleanliness (corrosive or particulate loads)
- Pressure drop and wheel depth trade-off
Verify
Use the Eurovent or AHRI 1060 certified latent effectiveness at your operating point, and confirm the media is rated for your airstream.
What This Product Does
This unit is built as a compact air-to-air heat exchanger that transfers thermal energy between two separate air streams without allowing them to mix. Warm exhaust air passes over one side of the core while cooler supply air passes over the other, and the temperature difference drives heat from the warm stream to the cool one. The result is pre-conditioned make-up air that needs far less external heating or cooling, which lowers the load on the building or process system.
Construction and Materials
The core is formed from corrugated aluminium or stainless-steel plates bonded into a counter-flow pack, with sealed channels that keep the two air paths isolated. Frames are typically galvanised or powder-coated steel, and service doors give access for inspection and cleaning. Gasket materials are selected for the operating temperature and any mild chemical exposure, so the unit stays reliable in demanding ventilation duties.
Where It Fits
In the Enthalpy Wheel Media Selection configuration the exchanger is suited to HVAC make-up air units, paint and coating ovens, food and pharmaceutical drying, and general process ventilation where energy cost is a concern. It can be mounted horizontally or vertically to match the available plant layout, and it connects with standard flanged ductwork for straightforward integration with existing fans.
Frequently Asked Questions
Does it need power to operate? The passive core needs no electricity; only the associated fans and controls consume power. How often should it be cleaned? Inspect at least once per season and clean the exhaust side when temperature recovery begins to drop.
Practical Selection Checklist
For the Enthalpy Wheel Media Selection duty, confirm the measured airflow and the temperature difference between the two airstreams before specifying any unit. Choose the core type that matches the exhaust cleanliness and the recovery target, allow margin for fouling, and verify the pressure drop stays inside the fan curve. Place filtration ahead of the core and provide a condensate drain where the supply side may fall below the dew point.
When to Specify This Solution
Energy recovery suits any plant or building that expels warm exhaust continuously while drawing in fresh air that must be conditioned from ambient. Common candidates include make-up air units, drying rooms, commercial kitchens, paint booths, and general process ventilation. Where the annual cost of heating or cooling make-up air is material, a correctly sized exchanger usually pays back within one to three operating seasons.
Next Steps
Start by logging the supply and exhaust conditions for a full duty cycle, then size the core from those numbers rather than from nameplate estimates. Compare the projected energy saving with the equipment and installation cost to get a payback figure, and review the comparison and product guides for the specific configuration that fits your site.